auto diagnostic One bolt is behind the grille on the left and proper in the bumper

How you can Set up a Jetta E-Code Headlight 1Press down on the tab on the back on the front grille to remove it.2Locate the 5 bolts that secure the bumper towards the frame.

One bolt is behind the grille on the left and proper in the bumper, and four are on the front side of each wheel wells. Get rid of the bolts then lift off the bumper. You'll need an Allen wrench or perhaps a large automotive diagnostic tool, hex head screwdriver to get rid of the bolts.3Remove the 4 screws holding the old headlight in spot. Two of them are at the bottom of your headlight auto diagnostic; the remaining two are on top rated.4Slide the headlight out.5Pull the wire plug out of your back of your headlight.

It need to slide out quickly but, if it doesn't, press a screwdriver into the hole on top rated in the plug.6Insert the wire plug in to the connector on the back with the new headlight.7Replace the headlight screws.8Reinstall the bumper and all of its bolts.9Slide the front grille back into its slot, making certain the tab you removed previously is re-secured in spot.